DFI SR330-N - Manual (Page 43)

43
2
Hardware Installation
S/PDIF Connector
The S/PDIF connector is used to connect an external S/PDIF port.
Your S/PDIF port may be mounted on a card-edge bracket. Install
the card-edge bracket to an available slot at the rear of the system
chassis then connect the audio cable connector to the S/PDIF con-
nector. Make sure pin 1 of the audio cable connector is aligned with
pin 1 of the S/PDIF connector.
W
1 5
+5V
Key
SPDIF out
GND
SPDIF in