DR Power Self-Propelled 6.75 Pro-XL (September 2010 - April 2013) - Manual (Page 31)

CONTACT US AT www.DRpower.com 31

Check to make sure the operator controls are moving freely. Lubricate the Throttle Lever, PTA

Lever (SPRINT

and PRO
models), and Key Switch with SAE 30 Oil if necessary.
 If your Engine has a Fuel Filter, replace it.

If your DR TRIMMER/MOWER will be idle for more than 30 days, we recommend using a gas stabilizer. This will prevent
sediment from gumming up the Carburetor. If there is dirt or moisture in the gas or Tank, remove it by draining the Tank.
Completely fill the Tank with fresh, unleaded gas and add the appropriate amount of stabilizer or gasoline additive. Run the
Engine for a short time to allow the additive to circulate.
 For Electric Start Model, store the machine in a dry environment with temperatures between +40°F (5°C) and +95°F (+35°C).
Make sure the storage temperatures will never be outside of these limits. The lower the storage temperature is within the
specified temperature, the better as the battery will discharge more slowly at low temperatures. If it is necessary to store the
Trimmer/Mower outside make sure to disconnect the battery and store it in an environment as listed above. Make sure the
disconnected battery terminals are not resting on any surface that may be prone to collecting water, snow or any other liquid as
this may cause damage to the terminals and to the battery when reconnected.

Oil Chains as needed.