DR Power Self-Propelled 6.75 Pro-XL (September 2010 - April 2013) - Manual (Page 35)

CONTACT US AT www.DRpower.com 35
Troubleshooting Table (Continued)
S YMPTOM P OSSIBLE C AUSE
The Drive Wheels won’t
turn (SELF-
PROPELLED model).  The Transmission Clutch may be out of adjustment. Adjust the Inline Adjuster located in
the Clutch Cable. See “Adjusting the Wheel Clutch” on page 27.
 The Drive Chains may have broken or come off the sprockets. Remove the Bottom Shield
to investigate. See page 21.
 The Drive Belt may have come off the pulleys, worn out or failed. Remove the Bottom
Shield to investigate. See page 21 and Drive Belt on page 23.
 Check to see that none of the Retaining Rings have slipped out of their grooves, allowing
the axel to slip sideways and cause binding in the chains. Remove the Bottom Shield to
investigate. If they have come out of their grooves, re-seat them by using a pair of Snap
Ring Pliers, or by pushing them back into the groove using a flat head screwdriver.
 Check to see if the Wheels rotate freely in each direction. They should freewheel in the
forward direction and lock against the axle going backwards. If they freewheel backwards,
the Drive Wheel Clutches may have failed. Call 1-800-DR-OWNER (376-9637) for assistance.
 If none of the above helps, visit our web site at www.DRPower.com or call 1-800-DR-
OWNER (376-9637) for assistance.
The machine creeps
forward without
squeezing the clutch
(SELF-PROPELLED
model).  The Transmission Clutch may be out of adjustment. Adjust the Inline Adjuster located in
the Clutch Cable. See “Adjusting the Wheel Clutch” on page 27.
 If the Trimmer still “creeps”, visit our web site at www.DRPower.com or call 1-800-DR-
OWNER (376-9637) for assistance.
Before performing any maintenance procedure or inspection, stop the engine, wait five (5) minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug.