DR Power 13 HP Towable User Manual
Page 29
Advertising
CALL
TOLL
FREE
1-800-DR-OWNER 25
3. Add a 5/16" Flat Washer to the end of the Bolt followed by a 5/16"-18 Lock Nut. Do not tighten at
this time.
4. Repeat Steps 2 and 3 for the lower Deflector attachment Bolt.
5. Pull up on the end of the Deflector and tighten the two (2) Lock Nuts.
6. Reconnect the battery negative terminal wire (Electric Start Model only), the spark plug wire and
start the Chipper engine; allowing the material in the Chipping Chamber to discharge.
7. If the Chipping Chamber does not clear and the flywheel is still jammed, repeat above process.
8. Be certain the Chipping Chamber is clear before trying to process more material into the Chipper
Hopper.
Advertising