Datalogic Scanning MAGELLAN 3200VSI - Manual (Page 70)

Interface Related Features
62
Magellan TM 3200VSi
Single Cable RS-232 Use ETX
Enables/disables the ability of the scanner to use ETX.
Set Single Cable RS-232 ETX Character
Allows selection of the ETX character.
To specify the ETX Character:
1. Scan the START/END bar code.
2. Scan the bar code, SET SINGLE CABLE RS-232 ETX CHARACTER below. You’ll need
to cover any unused bar codes on this and the facing page to ensure the scanner reads only
the bar code you intend to scan.
3. Scan the appropriate characters/digits from the keypad in Appendix C that represent the
decimal designation for the desired character. A table containing the ASCII Character Set
and their corresponding decimal values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning decimal digits for each character. Pad all
numbers with leading zeroes to yield a three-digit entry (001-127). Thus, to set a single
character value of A, bar codes containing the digits ‘0’, ‘6’ and ‘5’ must be scanned. The
selectable range for this option is any decimal value from 001 to 127.
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
SET SINGLE CABLE RS-232 ETX CHARACTER
START / END
PROGRAMMING bar codes
Disable ETX
Enable ETX
DEFAULT