Dish Network 112182 - Manual (Page 125)

Page 119
Test the System
T EST THE S YSTEM
S TART A NY T EST
1. Press the MENU button.
2. Select the System Setup option.
3. Select the Diagnostics option.
Note : “Diagnostics” are just “tests.”
4. Select the option for the test you want to do.
Note : If we upgrade the receiver software,we may add new tests.
T EST THE P HONE C ONNECTION
1. Make sure you connect a phone line to the receiver’s back panel
PHONE JACK .
2. Select the Connection option.The receiver
displays a message that asks you to wait until
the test is done.
• If the phone connection is okay, the receiver displays a
message that says so.
• If the receiver displays a message that
it needs to make a toll-free call to the
Customer Service Center, select the
Dial Out option.The receiver displays
a message that asks you to wait until
it finishes the call. When the receiver finishes the call, select
the
Cancel option.
• If you didn’t connect the phone line right, the receiver
displays a message that says so. Check the phone connection
and then do the test again.
Note : If you have a Digital Subscriber Line (DSL), you may
need to install a DSL filter between the receiver and the
telephone wall jack, and then do the test again.