Dish Network 112182 User Manual

Page 63

Advertising
background image

Page 57

Use Event Timers

Page 57

To use VCR Event Timers, you must set up the receiver to control the
VCR (see below). If the receiver can’t control the VCR, use an Auto-
Tune Event Timer
to tune the receiver to the channel you want to record.
Use the timers built into the VCR to start and stop the VCR at the right
times.

The receiver’s front panel IR BLASTER sends an IR signal to control
the VCR. This signal can bounce off walls or other objects on its way to
the VCR. This works in most home setups. But, shelves or smoked glass
doors between the receiver and the VCR can block the signal. If the
signal has to cross a very large room, or bounce off curtains, it may not
be strong enough to control the VCR. Make sure nothing blocks the
signal, and the signal can bounce off nearby, light-colored, smooth
surfaces.

If you can’t set up the IR BLASTER to control the VCR, maybe you
can use an IR extender you connect to the receiver ACCESSORY
JACK. An IR extender is a cable that carries the infrared signal from the
receiver to the IR sensor on the VCR. You can buy extenders from the
Customer Service Center. You must set up the receiver to send the right
signals out via the ACCESSORY JACK. Please see Set Up the
Accessory Jack
on page 81.

Here’s what to do:

The receiver starts the VCR to record, but doesn’t
turn the VCR on. So, you must leave the VCR turned on!

1. Get the VCR device code from the table in Device Codes starting on

page 121.

2. Press the MENU button.

3. Select the

System Setup

option.

4. Select the

Installation

option.

5. Select the

VCR Setup

option.

6. Use the number buttons to enter the VCR device code.

7. Make sure you turn on the VCR. If you are using the

TV Set Out

on the

receiver to provide audio/video to the VCR, set its channel switch to 3
or 4 to match the receiver back panel channel 3/4 switch and make sure
the VCR is set to record on this channel. Put in a rewound videotape
that you can record on.

Advertising
This manual is related to the following products: