Dish Network 112182 - Manual (Page 98)

Page 92
Chapter 4
Installation Instructions
2. Make sure the check mark is next to the satellite your dish will be pointed
toward.
3. If your Point Dish/Signal screen looks like the one on the left, continue to
step 4. If your Point Dish/Signal screen looks like the one on the right,
select Peak Angles and the Dish 300 option.
4. Select Peak Angles .
5. Use the number buttons on the remote to enter your ZIP code to get the
necessary azimuth and elevation. Write these numbers down in the spaces
provided in the margin.
6. Mount the dish antenna following the mounting instructions that came with
it.
7. Connect an RG-6 cable from the DishPro S AT I N connection on the receiver
directly to the DishPro LNBF on the Dish 300. Make sure t here are no
multi-dish switches between the LNBF and the DishPro receiver.
8. Select Check Switch from the Point Dish/Signal menu. When the Check
Switch screen opens, select Check .
9. When Check Switch is complete, you will see an Installation Summary
screen similar to the one shown next. It will show a connection (“Conn”
next to satellite) and
Single device under 1 (Dish Input). It may also show
an X on the Transponder line. This is okay and does not mean there is a
problem with the system.
Azimuth:
Elevation: