Use event timers, Chapter 3 – Dish Network 112182 User Manual
Page 54
Chapter 3
Page 48
Using the System
When You’ve Locked the Receiver
•
If you try to watch a locked channel or program, erase a protected
DishDVR recording, or open the
Locks
menu, the receiver displays a
message that tells you to enter the password.
•
The receiver gives you three tries to enter the right password. If you
can’t do this, the receiver doesn’t let you try again for several minutes.
If you enter the right password, you can watch a locked channel or
program or open the
Locks
menu.
•
If you leave a locked channel or program or the
Locks
menu, you must
enter the password again to see the channel, program, or
Locks
menu
again.
•
If you unlock the receiver, leave the locks unchanged, and then lock the
receiver again, you apply the same locks as before.
Personal Identification Number
You can set up a Personal Identification Number (PIN) for call-in requests
only. Anyone who calls the Customer Service Center must provide this PIN
to make any changes to your account, to buy services, or to get information.
You can call the Customer Service Center at 1-800-333-DISH (3474) at any
time to set up a PIN.
If you forget your PIN, you must call the Customer Service Center. We may
ask for more information to make sure it’s okay for you to make changes to
your account.
Use Event Timers
Many satellite TV programs and films are copyrighted. In some
cases, copyright law may apply to private, in-home recording.
Event timers let you set up the receiver to tune in future programs and/or
record them, with the DishDVR features or a VCR.
•
An “event” is a program, sports event, pay per view movie, or anything
else on satellite TV.
•
You can quickly set a one-time event timer with Quick Record. See
page 50.
•
You can set an automatic event timer for a program listed with start and
stop times in the
Program Guide
. This can be a program that comes on
each day or each week. See page 51.
•
A manual event timer lets you set custom start and stop times for a
timer. You can use a manual timer to record part of a program, several
programs together, or parts of several programs. See page 52.