Dish Network 112182 - Manual (Page 96)

Page 90
Chapter 4
Installation Instructions
19. You are now ready to verify reception from both satellites. Select the
Check Switch option. When the Check Switch menu opens, select
Check or Test. The receiver shows you a message that it is checking the
switches. When the procedure is finished, you will see an Installation
Summary screen. This screen may look different than the one shown
below. However, you must see that you have signals from both the 110
West and 119 West Satellites, you see “All” twice in the Transponder
line, and the message “Satellite reception verified. Press CANCEL or OK
to exit this menu.”
20. If you do not see “110” under Dish Input 2 :
• Make sure the skew angle you wrote down on page 84 is exactly the
same as the skew angle you set in step 5 on page 86. If it is not, reset the
skew angle as described on page 86. After you reset the skew angle, go
back page 89 and start over from step 16.
• If “119” is shown under Dish Input 2 , move the dish approximately 9°
to the east and restart the procedure at step 12.
21. Look at the Point Dish/Signal menu. If you have good signal strength
with the check mark in 119 West, move the check mark to 110 West. If
you have good signal strength on 110 West, go to step 22.
If you do not have good signal strength with the check mark in 110 West,
go back to Step 17, and fine-tune the dish but with the check mark in 110
West instead of 119 West. While the 110 West and 119 West signals will
not be equal, you should be able to fine-tune the dish until you have the
strongest possible signal from both satellites.
22. Select Cancel to exit the Point Dish/Signal menu. An Attention screen
will open asking the mounting and positioning of your dish is complete with
a “Locked” indication in the Point Dish/Signals screen. If the answer is yes,
select Yes.
If the answer is No, you will need to repoint your dish following the
preceding steps until the mounting and positioning is complete and you do
have the “Locked” indication.