Dish Network 112182 - Manual (Page 24)

Chapter 2
Page 18
Parts of the System
TV Set Out
This connection provides good picture quality and good mono
sound quality (even if you have a TV or other devices that
provide stereo sound).
If you use TV S ET O UT to watch satellite channels, you must
keep the TV(s) tuned to the same channel (either channel 3 or
4) as you selected on the Channel 3/4 Switch of the satellite
receiver.
The TV S ET O UT can be switched between satellite programming and the
signal on the TV A NTENNA /C ABLE I N connection using the TV/VIDEO
button on the remote control.
TV Antenna/Cable In
Use the TV A NTENNA /C ABLE I N to connect a broadcast TV
antenna or cable TV box to the receiver. The TV A NTENNA /
C ABLE I N connection is only available through the TV S ET
O UT as described above.
Phono (RCA) Audio/Video Outputs
These outputs provide high-quality picture and stereo
sound.
• If the TV has only one input for this type of audio,
connect it to the receiver’s R
IGHT A UDIO output.
• If you use these outputs to connect the receiver to other devices, be sure
to follow the instructions in the devices’ user manuals.
Super Video (S-Video) Output
The receiver provides S-Video, which is the highest quality video
available. If you use this output for video, you must still connect
the audio with the P
HONO (RCA) A UDIO O UTPUTS or the D OLBY
®
D IGITAL output.
Dolby ® Digital Output
The receiver provides Dolby
®
Digital encoded output and linear
Pulse Code Modulation (PCM) for an audio amplifier/decoder
that can process this kind of output.
Phone Jack
Connect a phone cable with a standard RJ-11 phone plug to the
receiver here, and then connect the cable to an active phone
jack.
Note : You must keep the receiver connected to a phone line at all times to
buy Pay Per View programs or use exciting interactive features.
Expansion Port
This port is reserved for future use.