Fluke Biomedical 10100AT - Manual (Page 8)

10100AT
Operators Manual
1-2
RS-232 Interface - remote operation, waveform capture, digital calibration, custom display units,
customer specified ion chamber calibration factors, and Model 35080/80A/80B kVp Divider filter packs.
Self-Checking - the Model 35050AT Dosimeter and Model 35080/80A/80B kVp Divider battery voltage
level, bias voltage level, ion chamber/cable leakage, and hardware/software checks.
1.3 Manual Addenda
Any improvements or changes concerning the instrument or manual will be explained in an addenda
included with the manual. Be sure to note these changes and incorporate them into the manual.
1.4 Before You Start - Safety Precautions
This instrument is intended for use by qualified personnel who recognize radiation hazards associated
with use of x-ray equipment.
Always turn off unit prior to connecting or disconnecting ion chamber or triaxial cable. Failure to do so
could result in electrical shock or damage to the equipment.
Beyond the battery and fuse, this unit contains no operator serviceable parts. The operator should not
attempt to gain access beyond the battery access cover. High voltage is generated internally and may
remain on internal parts even after the batteries have been removed.
1.5 Safety Symbols and Terms
The following symbols and terms are found on the instrument and used in this manual.
The symbol on the instrument indicates that the user should refer to the operating instructions
located in the manual.
The symbol on the instrument shows that high voltage may be present on the terminal(s). Use
standard safety precautions to avoid personal contact with these voltages.
The heading used in this manual explains dangers that might result in personal injury or
death. Always read the associated information very carefully before performing the indicated procedure.
The
heading used in this manual explains hazards that could damage the instrument.
Such damage may invalidate the warranty.
WARNING
CAUTION