FSR DV-MFSW-94 - Manual (Page 13)

13
6 Command List:
CON Connect input to output(s)
HAU
HDMI Audio Output command
HEDID
HDMI EDID setting
INSRC Input Source command
SAO Stereo Audio Output command
PRESET
Preset Recall command
RST
Reset DV-MFSW-94
BAUD Sets the RS232 baud rate
IPADR Sets the IP address
STAT
Universal Status command
NOTE:
All commands are terminated with a carriage return (0Dhex) represented by <cr>
The default baud rate is 38400 bps.
6.1 Set CON Command
Tells the DV-MFSW-94 which outputs to connect to which input
CON
id input “(“ output “,” output “,” ……”)”[“;” input”(“output,,,,”)”] <cr>
WHERE:
CON 3 ASCII byte command name
id 2 byte unit ID
input An input number between 0 – 9, zero representing no input.
“(“ Parentheses indicating the start of the outputs to connect the input to.
output an output number 1 – 4 to connect to the input. Multiple outputs can be included in the list
separated by a comma.
“)” Parentheses to end the list of outputs
“;” Delimiter separating additional definitions
<cr>
Carriage Return (0Dhex)
Example:
Connect Unit 01 input 1 to outputs 2, 3 and 4 and input 2 to output 1.
CON 01 1(2,3,4); 2(1)
<cr>