GAI-Tronics 295-001W, 295-001F Analog Clean Phone - Manual (Page 14)

P UB . 42004-484E
A NALOG C LEAN P HONE
®
T ELEPHONES P AGE 14 of 33
f:\standard ioms - current release\42004 instr. manuals\42004-484e.docx
01/15
Model 295-001W Clean Phone
®
The mounting and wiring instructions for the Model 295-001W Clean Phone ® are as follows:
1. Remove the front panel from the back box.
2. Place the modular RJ11 jack provided in the lower right corner of the back box.
3. Using the back box as a template, drill holes in the lower right and upper left corners of the mounting
surface and secure the back box with screws. Drill the holes in the pattern shown in Figure 8.
4. Place the bushing around the field telephone line and power cable approximately 8 inches from the
end of the cable. Snap the bushing closed and insert into the “D” hole in the back of the back box.
See Figure 3 and Figure 8.
5. Secure the back box to the mounting surface.
6. Connect the field telephone line to the RJ11 module.
7. Plug both the telephone line from the PCBA and the field telephone line into the modular jack. Plug
the power supply connector into P18 on the Push-Button Switch PCBA. Refer to Figure 4.
8. Perform the initial programming of the telephone. Refer to the “Standard Programming Mode”
section beginning on page 21.
9. Take the front panel of the Clean Phone ® and align it with the four slots in the back box.
10. Press the panel in firmly, and then push downward to seat the panel in the slots.
N OTE : The Model 295-001W is designed for general wipe down cleaning and to prevent collection
(internally and externally) of particulate matter.