GAI-Tronics 295-001W, 295-001F Analog Clean Phone - Manual (Page 21)

P UB . 42004-484E
A NALOG C LEAN P HONE
®
T ELEPHONES P AGE 21 of 33
f:\standard ioms - current release\42004 instr. manuals\42004-484e.docx
01/15
Standard Mode Programming
Prior to programming the Clean Phone ® telephones read the “Programming” section in its entirety, record
the desired key sequences and jumper settings.
The programming has been divided into two distinct subsections; “Standard Mode” and “SMART
Mode.” Standard Mode programming is used if the telephone system installation does not include the
TMA (Telephone Management Application) PC software. With TMA installed, the telephones will be
monitored and the SMART Mode programming should be used. Normal telephone operation is identical
in either mode of operation.
Each Clean Phone ® telephone is factory-programmed to receive Standard Mode commands. Factory-
default settings are shown in Table 12 on page 30.
Set-up Sequence
Set up each Clean Phone ® telephone for either “remote” access programming or for “local” access
programming.
Remote
Ensure that the auto-answer feature is enabled. (Refer to page 17.) Using a touch-tone telephone, call the
Clean Phone
® telephone. The telephone will automatically answer the call and generate a splash tone
(low to high sequence), followed by a success tone (short beep).
Local
Press the ON/OFF push button. When dial tone is heard from the speaker, simultaneously press the “1”
and “#” keypad buttons. The Clean Phone
® telephone will generate a splash tone (low to high sequence),
followed by a success tone (short beep).