Gasboy 9800 Atlas User Manual
Page 7
MDE-4687 Weatherproofing Instructions for Atlas™ 9800 Units · August 2007
Page 7
Installation of the Weatherproofing Kit
7
Remove the Hose Retriever or Blanking Plate by removing the two nuts inside the frame.
8
Remove the grommet (lubricate the Reset Shaft, if necessary).
9
Raise the top sheathing up slightly and pull the side sheathing away from the frame.
Note: Ensure that you do not bend the side sheathing.
10
Hold the side sheathing away from the frame to reinstall the grommet between the side
sheathing and frame (apply a small amount of lubricant for easy installation of the grommet
over the shaft). Place the larger diameter of the grommet against the frame. See
Figure 5: Installation of the Grommet Over the Shaft
11
Carefully relax the side sheathing and fit it over the Reset Shaft and grommet. See
.
Figure 6: Reset the Shaft and Grommet