Gasboy XU2A - Manual (Page 20)

Pump Maintenance
Page 20 MDE-4320 Gasboy UHF Pump, Blackmer® XU2A Rebuild Kit Installation Manual • June 2004
diameter of the grease seal (104) and push it into the inboard bearing cover (27A) with the lip
inward. The lip will face outward when the bearing cover is installed on the head. Attach a
new bearing cover gasket (26) and bearing cover (27A) to the inboard head. Install and torque
the bearing cover capscrews (28) to 15 lbs ft (20 Nm).
12 Attach a new bearing cover gasket (26) and the outboard bearing cover (27) to the outboard
head. Install and torque the bearing cover capscrews (28) to 15 lbs ft (20 Nm).
13 Push the dirt shield (123A) over the inboard shaft and firmly against the bearing cover.
Figure 4: Head O-Ring Installation