Gasboy Quarles NBS - Manual (Page 10)

Site Configuration
Page 6 MDE-4643 Quarles NBS Configuration and Software Installation Manual · March 2007
Site Configuration
This section highlights the configuration parameters that are required for the proper operation
of Quarles locations. Not all parameters are specified since many of the default parameters are
acceptable. Use the installation procedures in this manual to automatically load the appropriate
configuration, network and site data information. The following information is required to
verify if the installation has been performed properly.
Table
Match your table setup to the following screen capture. Items 6-12 may vary depending on the
number of devices at each site. For more information on these parameters, refer to
MDE- 4316 Site Controller III Configuration Manual.
Always run SYSBACK and TRANBACK prior to changing the table parameters. This
configuration program directly affects the way data is written to the memory. Changing this
table will redefine the memory allocation and could result in data loss. Proper backups are the
only way to ensure recovery after memory table reconstruction.
SYS_PAR
Page 1
• 2. Site ID - This number will vary from site to site and is designated by Quarles. Contact
Quarles at (877) 444-3835 if you are unsure of the number that is to be entered here.
• 7. PIN Key - This number will vary from site to site and is designated by Quarles. Contact
Quarles at (877) 444-3835 if you are unsure of the number that is to be entered here.
• All other items on Page 1 can retain their default settings.
Page 2+3
• All items on these pages can retain their default settings. Standard Gasboy Club Card
formats are not used with Quarles.