Geist R-Series PDU v4 - Manual (Page 28)

R-Series PDU v4 Instruction Manual 28
© 2014 Geist
Target is the e-mail address or SNMP manager to which notifications should
be sent when the Event is tripped. Other options, such as "buzzer", may be
available depending on your Geist PDU.
Delay determines how long this Event must remain tripped before this
Action's first notification is sent. (Note that this is different from the Trip
Delay, above; Trip Delay determines how long the threshold value has to be
exceeded before the Event itself is tripped.) Delay can be up to 14400
seconds (4 hours). A Delay of 0 will send the notification immediately.
Repeat determines whether multiple notifications will be sent for this Event
Action. Repeat notifications are sent at the specified intervals until the Event
is acknowledged, or until the Event is cleared and reset. The Repeat interval
can be up to 14400 seconds (4 hours). A Repeat of 0 disables this feature,
and only one notification will be sent.
Then, click Save to save this notification Action.
If required, multiple Actions can be set for an Alarm or Warning; to add multiple
Actions click the Add icon again and set each one as desired. Each alert can
have up to 32 Actions associated with it.
To change an existing notification Action, click the Modify icon next to the
Action you wish to change, then modify its settings as above.
Once an Action has been added, each Action has its own checkbox in the
"enabled" column at the far left. The default is unchecked (disabled) when you
first add each Action; set the checkbox to enable it. (This allows you to