Ivoclar Vivadent Lumamat 100 - Manual (Page 11)

11
4. Installation and Initial Start-Up
4.3 Assembly and initial start-up
– Power connection:
Make sure that the voltage indicated on
the rating plate (25) complies with the
local power supply.
Should this not be the case, you must not
connect the unit.
Connect the power cord (13) with the
power socket (10) of the unit and with the
power supply.
– Tempering space limiter (70)
The tempering space limiter is an optical
auxiliary device, defining the acceptable
tempering space for objects, together with
the mounted object holder. These
dimensions must be observed when
placing objects in the curing chamber,
since otherwise parts of the unit will be
damaged.
4.1 Unpacking and checking the
contents
Remove components from their packaging
and place the unit on a suitable table. There
are special transportation grips. The unit is
carried with one hand holding the grip at the
rear of the apparatus and the other hand
supporting the unit at the bottom, where
there is a recessed grip.
Never carry the unit by
holding the swivel arm.
Check the delivery for completeness (see
‘Delivery Form’ in Chapter 9) and transporta-
tion damage. If certain parts are missing or
damaged, contact Ivoclar Vivadent Customer
Service. We recommend keeping the original
packaging for future transportation
purposes. Make sure to place the
corresponding transportation safety devices
before transporting the unit.
4.2 Selecting the location
Place the unit on a flat surface using the
rubber feet (24). Make sure it is not placed in
the immediate vicinity of heaters or other
sources of heat. Furthermore, protect the
unit from direct sunlight. Make sure the air
may properly circulate between the wall and
the unit.
Remove the transportation safety
devices from the unit:
1. Safety tape
Check if all lamps are tightly fixed in their
sockets. Push the lamps upwards for that
purpose.
Position the unit in such a way that glare-free
working is ensured and no direct view into
the lamps is possible.
Make sure that there is enough space for the
swivel arm to prevent obstruction of the
swivel mechanism. The unit should neither
be placed nor operated in areas where there
is an explosion hazard.
Initial start-up
The unit may only be switched on or off with
the On/Off switch:
Switched on
Switched off
70