Ivoclar Vivadent Lumamat 100 User Manual
Page 13
Advertising
13
5.6 Acceptable tempering space
The parameters (light and temperature)
necessary for adequate curing and
tempering are only ensured within the
acceptable tempering space. The acceptable
tempering space is defined by the tempering
space limiter (70). The objects must be
placed within the acceptable tempering
space.
The necessary parameters (light and
temperature) are only ensured if the
plaster models used meet the following
requirements:
– Lighter than 400 g
– Height below 70 mm
– Diameter smaller than 80 mm
Acceptable tempering space
70
Advertising