Marantz SR9600N - Manual (Page 23)

19
ENGLISH
LEARNING COMMANDS
If an IR code or a brand is not in the database, you
can program RC3200B commands by transmitting
IR signals from your existing remote control units
to the RC3200B's learning eye. To do this, place
the RC3200B and the device's remote control unit
on a flat surface, 2.5 - 10 cm (1 - 4 inches) apart.
To learn commands from other remote control
units, RC3200B has to be in Learn mode.
Switching to Learn mode is only possible from the
Mode screen.
See “WORKING WITH MODES”. (See page 17)
For each device, you can learn all soft and hard
buttons on the RC3200B, except for:
• the BACKLIGHT button
• the page up and page down buttons
• the buttons to navigation bar
• the S button
THE LEARN SEQUENCE
1. Set the RC3200B to the Use mode.
See “WORKING WITH MODES”.
2. Select the device, e.g. DVD, with the
buttons you want to learn. The device
screen appears.
3. Press and hold the Mode button for 3
seconds. The Mode screen appears.
4. Tap Learn on the Mode screen.
LEARN
DVD
Main
1/4
Done BWD FWD
The RC3200B is now in the Learn mode.
“LEARN” and the label of the selected
device appear at the top of the LCD touch
screen.
5. Use, if necessary, the page up or page
down button to go to the next button you
want to learn.
6. Press the soft or hard button you want to
learn on the RC3200B.
T h e “ L E A R N ” l a b e l c h a n g e s t o
“LEARNING”, which means RC3200B is
ready to receive commands from an existing
remote control unit.
The RC3200B will wait for 5 seconds to
receive an IR code from another remote
control unit.
Note:
When a hard button is pressed to learn, there is
no onscreen feedback to indicate which button
is pressed.
7. Press and hold the button on the existing
remote control unit you want to learn to the
RC3200B.
When the RC3200B receives an IR code:
• A confirmation beep will sound.
• The label changes from “LEARNING” to
“OK”. The learn sequence is successful.
OK
DVD
Main
1/4
Done BWD FWD
When the RC3200B does not receive an IR
code within 5 seconds:
• An error beep will sound.
• The label changes from “LEARNING” to
“FAILED”. The learn sequence has failed.
• The RC3200B will return to the Learn mode.
Return to step 5 of the learn sequence to
relearn the button.
Tip:
You do not have to wait for the “OK” or
“FAILED” to disappear. If you press another
button (soft or hard), the RC3200B learn sequence
immediately goes back to step 5.
8. Go to other pages of the selected device with
the page up and page down buttons.
Repeat steps 6 and 7 until you have copied all
the commands of the existing remote control.
9. Press Done button when you have finished
learning commands on the buttons of your
choice.
The RC3200B returns to the Use mode. You
can try out the new IR codes or select another
device to learn.
H
M
Ex
S
OK
H
M
Ex
S
OK
Side View Side View
Top View Top View
DVD remote
control unit
DVD remote
control unit
DVD remote
control unit
RC3200B
RC3200B
RC3200B
OK
RC3200B
NO GOOD
2.5 - 10 cm (1 - 4 inchs)
DVD remote
control unit
SR9600N DFU_01_ENG 2_4 05.5.23, 5:43 PM Page 19 Adobe PageMaker 6.5J/PPC