Marantz SR9600N - Manual (Page 30)

26
ENGLISH
USB AUDIO
OUTPUT INPUT-1 (DVD)
INPUT-2 (DSS) INPUT-1 (DVD) INPUT-3 (VCR-1)
2
CD
INPUT-2 (DSS)
2
1 1
2
3
4 4
3
RS232C DC OUT EMITTER OUT MULTI RC RC-5
MONITOR OUT 1 OUT IN OUT IN DSS TV DVD LD
TAPE
VCR-1
OUTPUT-2
OUTPUT-1
IN
MAIN IN 7.1CH IN MULTI OUT
SURR. RIGHT
SURR. LEFT
SPEAKER SYSTEMS FRONT A OR B, CENTER, SURR,
SURR BACK : MINIMUM 6 OHMS
FRONT A + B : MINIMUM 8 OHMS
CENTER
FRONT B RIGHT
FRONT B LEFT
FRONT A RIGHT
FRONT A LEFT
SL SBL SL SR SBL SBR
SW
A B
SBR SR
COAX
OPT
8
7
6
2
5
4
3
1
DIGITAL IN
DIGITAL OUT
OUT
AC IN
CB/PB CR/PR Y CB/PB CR/PR Y CB/PB CR/PR Y CB/PB CR/PR Y
CB/PB CR/PR Y
R
L
MODEL NO. SR9600
TUNER-1
FM(75 Ω ) GND AM
FM(75 Ω ) GND AM
TUNER-2
(AUDIO)
S400
S400
INPUT-4 (VCR-2 / DVD-R)
VCR-2 / DVD-R
IN CD-R / MD OUT
R
L
(AUX 2)
C
AUDIO
PRE OUT
L R C
AUDIO SW
VIDEO
S-VIDEO
R
L
MULTI OUT
VIDEO
A B
COMPONENT VIDEO
HDMI Ver 1.1
FLASHER RECEIVER IN IN
IR
OUT
IN
SURR.BACK /MULTI SPK. /SPK. C RIGHT
SURR.BACK /MULTI SPK. /SPK. C LEFT
ON
OFF SPEAKER C
UNSWITCHED 100W MAX
AC OUTLET 230V 50/60HZ
TUNER-1
FM(75 Ω ) GND AM
FM(75 Ω ) GND AM
TUNER-2
TUNER-1
GND AM
GND AM
TUNER-2
CONNECTING THE ANTENNA TERMINALS
FM ANTENNA
FM EXTERNAL
ANTENNA AM LOOP ANTENNA AM EXTERNAL
ANTENNA
ASSEMBLING THE AM LOOP ANTENNA
1. Release the vinyl tie and take out the connection
line.
2. Bend the base part in the reverse direction.
CONNECTING THE SUPPLIED ANTENNAS
Connecting the supplied FM antenna
The supplied FM antenna is for indoor use only.
During use, extend the antenna and move it in
various directions until the clearest signal is
received.
Fix it with push pins or similar implements in the
position that will cause the least amount of
distortion.
If you experience poor reception quality, an
outdoor antenna may improve the quality.
Connecting the supplied AM loop antenna
The supplied AM loop antenna is for indoor use
only.
Set it in the direction and position it to where you
receive the clearest sound. Put it as far away as
possible from the unit, TVs, speaker cable, and
power cord.
If you experience poor reception quality, an outdoor
antenna may improve the quality.
1. Press and hold down the lever on the AM antenna
terminal.
2. Insert the bare wire into the antenna terminal.
3. Release the lever.
Note:
• Connect the shielded grounding wire (black) to the
AM antenna GND terminal.
CONNECTING AN FM OUTDOOR ANTENNA
Notes:
• Keep the antenna away from noise sources (neon
signs, busy roads, etc.).
• Do not put the antenna close to power lines. Keep
it well away from power lines, transformers, etc.
• To avoid the risk of lightning and electrical shock,
grounding is necessary.
CONNECTING AN AM OUTDOOR ANTENNA
An outdoor antenna will be more effective if it is
stretched horizontally above a window or outside.
Notes:
• Do not remove the AM loop antenna.
• To avoid the risk of lightning and electrical shock,
grounding is necessary.
3. Insert the hook at the bottom of the loop part
into the slot at the base part.
4. Place the antenna on a stable surface.
ANTENNA
SPLITTER
SR9600N DFU_01_ENG 3_4 05.5.23, 5:47 PM Page 26 Adobe PageMaker 6.5J/PPC