NavCom RT-3020 Rev.A - Manual (Page 35)

RT-3020 User Guide
5-33
Maintenance
The NavCom equipment can be cleaned using a new
lint free cloth that may be moistened, but only with
pure alcohol.
Connectors must be inspected and if necessary cleaned
before use. Always use the provided connector
protective caps to minimize moisture and dirt ingress.
Cables should be regularly inspected for kinks and cuts
as these may cause interference and equipment failure.
Damp equipment must be dried at a temperature less
than +40°C (104°F), but greater than 5°C (41°F) at the
earliest opportunity.
External Power Source
The RT-3020 is supplied with an external power cable
(
P/N 94-310060-3010). This must be connected to the
chosen external power solution in accordance with
Chapter 2 Interfacing\Electrical Power. It is important
that the external power source allow sufficient current
draw for proper operation. Insufficient supplied current
will case damage to your external power source.
If your chosen external power source is a disposable
battery, please dispose of the battery in accordance
with your local regulations.
Safety First
The owner of this equipment must ensure that all users
are properly trained prior to using the equipment and