NIStune Type 4 - Manual (Page 12)

Type 4 Hardware Installation Manual Page 11 of 21
• Change ECU jumper settings
Jumpers are used on the ECU to tell it to read from either standard factory code (located in a memory
chip on the ECU main board) or from the NIStune board. Move the jumpers as per the following table.
Refer to Appendix B for some practical tips on moving the jumpers
.
Move
Jumper
Model Name Engine Jumper Position ECU PN 23710 -
R021 to R020
S14a Silvia SR20DET
Top side of ECU near
large square IC
80Fxx, 82Fxx, 83Fxx
S15 Silvia SR20DET 91Fxx, 93Fxx
P11 Primera SR20DE 3J4xx, 3J5xx, 3J8xx, 3J9xx, 71Jxx
N15 Almera Gti SR20DE 1N4xx (UK)
S13 180SX late SR20DET 60Fxx
W10 Avenir late SR20DET 95N15
K11 Micra CG13DE
Rear of ECU
0U4xx, 101xx, 74Bxx (98 – 02)
R025 to R022
N15a Pulsar GA16DE 1N90x
P10 G20 Infiniti SR20DE 0J2xx 0J6xx (to 1995)
U13 Altima KA24DE 3E6xx, 48Exx (1995 – 1996)
S14 240SX KA24DE 70Fxx (1995)
S14 240SX KA24DE 72Fxx (1996 Dual ROM)
B14 Sentra GA16DE 0M2xx
B14 Sentra SR20DE 1M8xx, 0M76x, 2M0xx
J923 to J922
Y33 Cedric/Cima VQ30DE(T)
4P2xx
J932 to J933 6P5xx
J904 to J905
and
J903 to J902
ER34 Skyline RB25DET AA5xx (NEO engine)
WC34 Stagea S2 RB25DET 0V8xx (NEO engine)
B14 Sentra SR20DE Not available
J031 to J030
A32 Maxima VQ30DE 40Uxx, 49Uxx, 54Uxx (Dual ROM)
Z32 300ZX VG30DETT 54Pxx (1996 Dual ROM only)