NIStune Type 4 - Manual (Page 18)

Type 4 Hardware Installation Manual Page 17 of 21
• Appendix A
NIStune Board Jumper Settings Listing
Fit
Jumper
Model Name Engine Remarks ECU PN 23710 -
J2
S14a Silvia SR20DET Adaptor A, SR20DE not supported 80Fxx, 82Fxx, 83Fxx
S15 Silvia SR20DET Adaptor A, SR20DE not supported 91Fxx, 93Fxx
Y33 Cedric VQ30DET Adaptor B 4P2xx
K11 Micra CG13DE Adaptor A, “facelift” model 98-02 0U4xx, 101xx, 74Bxx
P11 Primera SR20DE Adaptor A 3J4xx, 3J5xx, 3J8xx, 3J9xx, 71Jxx
N15 Almera Gti SR20DE Adaptor A, UK model 1N4xx
N15a Pulsar GA16DE Adaptor B 1N90x
W10 Avenir SR20DET Late model (>97) only 95N15
J1+J2
P10 G20 Infiniti SR20DE Adaptor B, USDM to 1996 only 0J2xx 0J6xx
U13 Altima KA24DE Adaptor B, USDM to 1997 only 3E6xx, 48Exx
S14 240SX KA24DE Adaptor B, USDM to 1996 only 70Fxx, 72Fxx
B14 Sentra SR20DE Adaptor B, USDM to 1997 only 1M8xx, 0M76x, 2M0xx
A32 Maxima VQ30DE Adaptor B 40Uxx, 49Uxx, 54Uxx
Z32 300ZX VG30DETT Adaptor B 1996 only 54Pxx
J3 S13 180SX late SR20DET Adaptor A, “Late 180SX” Type X/R 60Fxx
J1 + J3
ER34 Skyline RB25DET Adaptor C, RB25DE not supported AA5xx
WC34 Stagea S2 RB25DET Adaptor C, NEO engine only 0V8xx
For end user there is no need to change jumpers. This table is provided for reference only.
But for tuners/distributors who wish to program the board for use in a different type of ECU it must first be
reprogrammed with the required BASE ROM IMAGE, and then jumpers set for the vehicle as per above table.
To program base image:
1) Solder the PGM (J4) jumper and open all others (J1-J3)
2) Program the board using NIStune Base Image Programmer (see separate instructions on NIStune website)
3) Remove PGM (J4) jumper and set other jumpers (J1-J3) as per table above