Orion System Water Source Heat Pump X Module - Manual (Page 24)

WSHP-X Module
Technical Guide 24
System Status B Screens
SYSTEM B, COMPRESSOR 2
This screen displays the current status of the B2 Compressor.
OFF
PENDING: Compressor is off, but a request is made to be on, but the
1 minimum off time has not been met.
ON: HEAT or Cool
REASON FOR FAILURE: Low Pres, Lockout, Low H2O, No Flow
LEAVING WATER TEMPERATURE READING
OR “NO SENSOR”
PO FLOW
YES or NO
PROOF OF WATER FLOW
B1 PRES
XXX
SYSTEM B, COMPRESSOR 1 PRESSURE READING
B2 PRES
XXX or NOT USED
SYSTEM B, COMPRESSOR 2 PRESSURE READING
If Single Water Confi guration, this screen will display “NOT USED.”
System Status B Screens
Refer to the following map when navigating through the System Status
B Screens. From the SYSTEM STATUS B Screen, press
<ENTER>
to
scroll through the screens.
SYSTEM
STATUS B
Status Screens shown below will scroll automatically if LCD display is
left on this screen for 20 seconds.
SYSTEM B, COMPRESSOR 1
This screen displays the current status of the B1 Compressor.
OFF
PENDING: Compressor is off, but a request is made to be on, but the
1 minimum off time has not been met.
ON: HEAT or Cool
REASON FOR FAILURE: Low Pres, Lockout, Low H2O, No Flow
SYSTEM B
DISABLED
If System B is disabled, the above screen will appear.
B1 COMP
OFF,PENDING,ON or
Reason for Fail
B2 COMP
OFF,PENDING,ON or
Reason for Fail
H2O TEMP
NO SENSR
AOUT1
X%
ANALOG OUTPUT 1 PERCENT
0 - 100%
AOUT2
X%
ANALOG OUTPUT 2 PERCENT
0 - 100%