Scotsman HID312 Service Manual - Manual (Page 15)

HID312, HID525, HID540
Service Manual
April 2015
Page 15
Controller Functions
The controller has features for the service technician. Some details
• Any auger motor failure is an immediate shut down. Because of the critical nature of that failure there is no
auto restart from an auger error.
• An open Water Sensor (dry probes) will stop the machine. Because water can be restored at any time,
whenever both Water Sensor probes are wet again AND the compressor has been off for at least two minutes,
ice making will restart.
• An open High Pressure switch will stop the machine. Because the pressure switch is an automatic reset,
when it closes AND the compressor has been off for at least two minutes, ice making will restart.
• Fault Code View: Push and HOLD the vend disable button then push and hold the on/off button for 3
seconds or until Status light is on. Release both. Pushing Clean will cycle thru the available codes, the total
number of codes stored is 30.
• Clear codes: Push and HOLD the vend disable button then push and hold the Clean button for about 3
seconds. The display code will blink 3 times. Release both.
• The compressor will not restart until it has been off for at least 2 minutes.
• There is a Test Mode. The Test Mode operates each load in sequence to confirm that it is being powered
by the controller.
To start Test Mode: Push and HOLD the ON/OFF button; at the same time, push and HOLD the CLEAN button.
When a “d” appears in the code display, release the buttons, the test mode will begin.
Time (seconds) On Off
0 Compressor Auger Gear Motor, Water Disp, Ice Disp
10 Compressor and Auger Gear Motor Water Disp, Ice Disp
20 Auger Gear Motor Compressor, Water Disp, Ice Disp
30 Water Dispense Auger Gear Motor, Compressor, Ice Disp
35 Ice Dispense Auger Gear Motor, Compressor, Water Disp
40 None All – Test Complete
• The Time to Clean indicator light glows when 6 months of power up time have elapsed. When it is on it
does NOT stop ice making. It is cleared and reset when the Cleaning process has been completed.
• The Cleaning process, described in detail in the Maintenance section, is initiated by a press of the Clean
button. The auger motor will be operating during the entire Clean mode. No ice will be made. The scale is
dissolved by the action of the scale remover and the auger’s motion.
• Pushing the Disable switch closes contacts of the switch, signalling the controller to ignore the dispense
sensor’s signals for 60 seconds.
• USB firmware updates may become available. To update the unit must be in Test Mode and then a USB
stick with ONLY the update on it is inserted into the USB connector. L will be displayed during the Loading
process. After a few seconds the top five LEDs begin scrolling up for about 75 seconds then the LEDs start
scrolling down for about 20 seconds. At the end “0” is displayed. Unplug the USB drive.
Note: If during the update process the display flashes between “L” and “F” that means that the Load Failed. If
that happens, unplug the USB drive, then power cycle the control board. If “0” is not displayed, press the On/
Off button. The controller will revert to the original firmware.