Scotsman HID312 Service Manual - Manual (Page 26)

HID312, HID525, HID540
Service Manual
April 2015
Page 26
Controller Diagnostics
Code or Light Action Probable Cause Suggested Action
O
Unit manually switched off If desired, switch unit on.
F
Freeze mode None, unit is making ice.
b
Bin sensors sense bin full Check if bin is full.
E
Corrupted memory Replace controller
C
Clean mode Continue clean mode
d
Test mode None, allow unit to finish test
mode.
1
Auger motor rotated auger
backwards.
Replace auger motor. Check water
seal area for leaks, replace seal if
leaking.
2
Auger motor stalled or operating
slowly
Clean ice making system and retry.
If unit shuts off again right after a
reset, magnet rotor on motor shaft
may be loose.
3
No water in reservoir Restore water. If there is water,
is it too pure? Are sensor wires
connected?
4
High pressure cut out open Check fan motor on air cooled or
water supply on water cooled.
Water dispense sensed light
blinking
Container positioned in front of
water dispense sensor for more
than 24 seconds
Normal, controller has a time limit
for dispensing. Remove container.
Water dispense light blinking
Ice dispense sensed light blinking
Container positioned in front of ice
dispense sensor for more than 20
seconds.
Ice dispense light blinking
Status light is on Unit is in ice making mode Normal, may not be making ice if
bin is full
Time to Clean light is on Unit has not been cleaned for at
least 6 months
Clean unit
Water Dispensed Sensed light is
on
A container is in front of the sensor Normal during water dispensing
Ice Dispensed Sensed light is on A container is in front of the sensor Normal during ice dispensing
Water Dispense light is on Water solenoid has been activated Normal during water dispensing
Ice Dispense light is on Bin drive motor has been activated Normal during ice dispensing
Auger light is on Auger motor is active Normal when making ice
Compressor light is on Compressor is active Normal when making ice