Teac DR-60D - Manual (Page 35)

TASCAM DR-60D
35
3 – Preparation
Turning the power on and off (putting it in
standby)
CAUTION
• The unit goes in standby mode if shut down when the unit is
operating on AC power supplied through the TASCAM PS-P515U
AC adaptor (sold separately), or bus power supplied from a USB
port of a PC.
• Turn down the volume of the sound system connected to the unit
before starting up or shutting down (standby) the unit.
• Do not use headphones when starting up or shutting down
(standby) the unit. Otherwise, a large noise would cause damage
to headphones or your ears.
Starting up the unit
To start up the unit from the stopped state, press and hold the ¤
button until
TASCAM DR-60D
(start-up screen) is displayed on the
display. The Home Screen appears when the unit starts up.
Start -Up Screen Home Screen
CAUTION
When the unit is started up for the first time (or when the built-in
clock is reset after being left unused without batteries), the
DATE/TIME
screen appears before the start-up screen to adjust
the date and time. (See “Setting the date and time” on page 36.)
Shutting down (putting the unit in standby)
Press and hold the ¤ button until
LINEAR PCM RECORDER
appears on the display.
The power turns off after the unit completes its shutdown (standby)
process.
CAUTION
Always use the ¤ button to shutdown (standby) the unit.
Do not remove the batteries or disconnect the power cable (AC
adaptor TASCAM PS-P515U or USB cable) accidently while the
unit is operating. If you do so, the unit cannot shut down properly
and all recordings, settings and other data will be lost. Lost data
cannot be restored.