Teac DR-44WL Reference Manual - Manual (Page 44)

44
TASCAM DR-44WL
10– Useful functions
Tuner function (compatible with
V1.10)
A guitar and wind instruments can be tuned using a built-in
chromatic tuner.
The tuner incorporated into this unit has chromatic tuner mode
that allows tuning of musical instruments while looking at
the tuning meter and oscillator mode that outputs reference
sounds.
Chromatic tuner
1. Connect a guitar or bass to the 1/L connector of the EXT
MIC/LINE IN jack.
You cannot tune if you connect it to the 2/R connector.
Tune wind instruments using the built-in microphone.
2. Press the MENU button to open the MENU screen.
3. Using the wheel, select (highlight) TOOLS and press the
ENTER/MARK or / button.
TOOLS
screen appears.
4. Using the wheel, select (highlight) TUNER and press the
ENTER/MARK or / button.
TUNER screen appears.
5. Using the wheel, select (highlight)
MODE
and press the
ENTER/MARK or / button.
6. Use the wheel and ENTER/MARK button to set tuner mode
to CHROMATIC .
Options:
CHROMATIC
(default value) ,
OSC
.
7. Using the wheel, select (highlight)
SOURCE
and press the
ENTER/MARK or / button.
8. Use the wheel and ENTER/MARK button to set the input
destination you want to tune sounds.
Options Input destination
INT L
(default value)
Input from the built-in microphone
EXT 1
Input from the 1/L connector of the
EXT MIC/LINE IN jack
NOTE
To use
EXT 1
, set the EXT IN switch to LINE.
9. Using the wheel, select (highlight)
CALIB
and press the
ENTER/MARK or / button.
10. Use the wheel and ENTER/MARK button to set the funda-
mental frequency of the A.
Options:
435Hz
-
445Hz
(default value:
440 Hz
)
11. Perform tuning by playing a musical instrument.
The note that is closest to the sound you played is shown at
the top of the tuning meter.
Tune the musical instrument so that the note you want to
match is shown and the center of the tuning meter lights up.
A bar appears on the left or right of the center if the sound
is lower or higher than the target pitch. The bar becomes
longer as the sound shifts away from the target pitch.
When the sound played matches the note exactly, tg on
the right and left of the note lights up.
12. Once tuning has been completed, press 8/HOME button to
return to the Home screen.
Oscillator mode
1. Press the MENU button to open the MENU screen.
2. Using the wheel, select (highlight)
TOOLS
and press the
ENTER/MARK or / button.
TOOLS screen appears.
3. Using the wheel, select (highlight) TUNER and press the
ENTER/MARK or / button.
TUNER
screen appears.
4. Using the wheel, select (highlight) MODE and press the
ENTER/MARK or / button.
5. Use the wheel to set tuner mode to OSC .
Options:
CHROMATIC
(default value) ,
OSC
.
6. Press ENTER/MARK or . button to change the
TUNER
screen to the oscillator mode display.
The following settings can be made in the oscillator mode
display.
NOTE
Set the sound to output.
The setting range is from
C3
to
B5
. (default value:
A4
)
LEVEL
Set the output level.
The setting range is from
10 (minimum) to 100
(maximum). (default value: 50 )