Teac DP-03 - Manual (Page 14)

14
TASCAM DP-03
2 Press the TRACK 1 REC button.
The TRACK 1 REC indicator blinks and the unit enters
record standby.
TRACK 1 REC indicator
3 Use the INPUT A TRIM knob to adjust the guitar
input level.
Set the TRIM knob so that the OL indicator for
INPUT A does not light even when the loudest
sound to be recorded is input.
If the OL indicator continues to light even when the
TRIM knob is turned down, the guitar signal itself is
too loud. In this case, lower the output level on the
guitar.
OL indicator
When you play guitar, the input level is shown by the
level meters for “ ” (INPUT A) and “ ” (TRACK 1) on
the display.
When you raise the TRACK 1 fader, the MASTER fader
and the PHONES LEVEL knob, you can hear the sound
of the guitar through the headphones, and the
and
level meters move.
NOTE
Use the •
TRACK 1 PAN knob to set the stereo position
when monitoring.
When the
•
TRACK 1 REC indicator is unlit, the input
cannot be heard.
Recording a guitar to TRACK 1
1 Press and hold the RECORD (º) button and press
the PLAY (Á) button to start recording. Play the
guitar.
The TRACK 1 REC indicator stop blinking and stays lit.
TRACK 1 REC indicator
2 When you are done performing, press the STOP (ª)
button to stop recording.
3 Press the TRACK 1 REC button to end record
standby. Its REC indicator becomes unlit.
2 – Quick Start Guides