Teac DP-03 - Manual (Page 48)

48
TASCAM DP-03
Automatically punching in and
out
When an IN point and an OUT point are set, press the
AUTOPUNCH button to enter auto punch in/out mode.
Auto punch in/out
mode icon
Auto punch in/out mode includes a rehearsal function.
When using this function, monitoring between the IN and
OUT points in the same way as when recording is possible
without actually recording.
Rehearsal
1 When the recorder is stopped, press the MENU
button to open the
MENU
screen.
2 Press the REC buttons on tracks to use auto punch
in/out with them.
3 After setting the IN and OUT points, press the
AUTOPUNCH button to enter auto punch in/out
mode.
4 Press the PLAY (Á) key.
Playback begins from two seconds before the IN point,
and the sound monitored on the recording track(s)
switches at the IN point from the track playback sound
and the input sound to just the input sound. The
RECORD (–) indicator blinks when between the IN
and OUT points.
When playback reaches the OUT point, the track
playback sound and the input sound becomes the
monitored sound again, and the RECORD (–) indicator
stops blinking and turns off. Playback automatically
stops one second after the OUT point.
You can repeat rehearsal until you are satisfied.
Using auto punch in/out to record
When you are done rehearsing, you can use auto punch
in/out for recording.
1 While in auto punch in/out mode, press and hold
the RECORD (–) button, and press the PLAY (Á)
button.
In the same way as during rehearsal, playback begins
from two seconds before the IN point. Recording
occurs and the RECORD (–) indicator lights between
the IN and OUT points.
2. One second after reaching the OUT point, the
recorder automatically stops, auto punch in/out
mode is exited and the transport locates to two
seconds before the IN point.
NOTE
Auto punch in/out mode cannot be entered during •
repeat mode or if no REC button has been pushed.
Auto punch in/out can be undone.
•
7 – Recorder Functions