Teac DV-W14R - Manual (Page 23)

1 Copy
Rackmount DVD/CD Duplicator User’s Manual 15
Chapter 3. Rackmount DVD/CD Duplicator Functions
The DVD/CD Duplicator features 12 functions: Copy, Test, Test &Copy, Verify,
Compare, Prescan, Disc Info, Select Source, Image, Edit Track, Setup, and
Advanced Setup. Each function is explained below.
1 Copy
The Copy function enables you to copy data from a source DVD or CD disc or a
partition on the internal hard disk drive. For more detailed information, refer to
“Basic Operation” on page 9.
2 Test
The Test function simulates writing to the target disc. Discs will remain blank
after the test is complete. This function is recommended if you are using
unsupported media. This function enables the target drive to adjust its laser to the
proper intensity.
3 Test & Copy
The Test & Copy function performs the test simulation and the copy process in one
step.
The copy process is performed only if the simulation detects no problems. If the
simulation fails, the copy process is cancelled.
4 Verify
The Verify function verifies that the target disc was written completely and with
no errors.
Note: You can use DVD±RW discs that already contain data (i.e., DVD±RW
discs that are not fully blank) as target discs. However, the data stored on the
DVD±RW disc will be erased automatically before the new data is copied. No
special setting or procedure is required to erase the old data.
Note: Unexpected termination or cancellation of a test will not affect a target
DVD±R disc. The target DVD±R disc will remain blank and available for use.
However, DVD±RW discs that contain data may be damaged and the data they
contained may be rendered unrecoverable. It may be necessary to re-start the
DVD/CD Duplicator if the target drive hangs during a sudden termination.