Thinklogical Touch Panel Manual - Manual (Page 14)

Revision B JULY 2010 8
The Touch Panel will blank its screen and reboot with new values.
If you are using the Remote Configuration method on multiple Touch Panels, watch to see which
panel blanks and reboots so you can tell which one
you‟ve just configured and label it with the
proper IP address.
Using the Touch Panel
Detail Screen
The Touch Panel will load the operating system, start the GUI, and get the updates from the
server. The following screen should display the GUI:
Figure 4: Touch Panel displaying the GUI
The Touch Panel starts up in “Detail” mode by default.
SOURCES are listed on the right (ex: CPU 01, CPU 02, CPU 03, CPU 04).
DESTINATIONS are listed on the left (ex: DESK 01, DESK 02, DESK 03, DESK 04).
The buttons shown at the bottom of the screen are command buttons which perform a task.
Connect will connect your destination to a source by pressing, where Take
Mouse will „take the
mouse‟ from all other connections and give it to the source/destination combination the user has
selected. You can also run Macros by clicking on the Macros button and then run the selected
Macro.
Page
Up
Page
Down
Page
Up
Page
Down