Part 2: set-up and installation set-up – Thinklogical VX640 Router Manual User Manual
Page 20
VX640 Router Manual, Rev. C
15
March, 2013
VX640 Transmit/Receive Concept
PART 2: SET-UP AND INSTALLATION
Set-Up
All physical connections to the product use industry-standard connectors. Non-supplied cables that may
be needed are commercially available. All connections are found on the rear of the unit.
Note: Insure that all thumb screws are finger tight so that all the modules are properly
held in the chassis.
Step 1
Carefully remove the VX640 KVM Matrix Switch from its shipping container. Inspect the router to
make certain that no damage occurred during shipment.
Step 2
All of the I/O cards are installed at the factory to meet your specific configuration. Insure that the I/O
cards are properly seated in the unit and that all the SFP modules are sealed with a removable
dust plug. All of the I/O cards are held in place by thumb screw retainers.