Thinklogical VX640 Router Manual - Manual (Page 28)

VX640 Router Manual, Rev. F 23 November, 2013
The Power Modules are universal input 120-240VAC 50-60Hz. Use the proper power cord for your
region (supplied with the unit). Although the router functions properly with two Primary Power Modules,
it is recommended that all four Modules (two Primary, two Back-up) be connected to two independent
power sources (for redundancy).
Step 1
Grasp the black handle with one hand.
Step 2
Slide the green tab to the left with the other hand.
Step 3
Pull the Power Module out of the chassis.
Step 4
Insert the new Power Module into the chassis and slide it in until it reaches the backplane connector.
The module should slide freely until it reaches the backplane connector. At this point, use just
enough force to firmly engage the card with the mating connector.
Warning! If the module does not slide easily into the connector, do not force it! Damage
may occur. Remove the module and start over.
PART 3: REGULATORY & SAFETY REQUIREMENTS
Symbols Found on Our Products
Markings and labels on our products follow industry-standard conventions. Regulatory markings found
on our products comply with domestic and many international requirements.
Regulatory Compliance
Thinklogical
®
products are designed and made in the U.S.A. Our products have been tested by a
certified testing laboratory and found to be compliant with the following standards (both domestic USA
and many international locations):
North America
Safety
ANSI/UL60950-1: 1
st
Edition (2003)
CAN/CSA C22.2 No. 60950-1-03
LASER Safety
CDRH 21CFR 1040.10
Class 1 LASER Product
Electromagnetic Interference
FCC CFR47, Part 15, Class A
Industry Canada ICES-003 Issue 2, Revision 1
Australia & New Zealand
This is a Class A product. In a domestic environment this product may cause radio interference, in
which case the user may be required to take adequate measures.