Desa VMH10TPC - Manual (Page 21)

www.desatech.com 112462-01F 21
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
(HRC100 & HRC200 Series)
Installing Receiver
1. Disconnect jumper wire from control valve
(see Figure 27).
2. Locate battery clip mounted on back of re-
ceiver (see Figure 28).
3. Slide 9-volt battery (not included) through
clip.
4. Attach terminal wires to battery (see Figure 29).
5. Connect wires from remote receiver to control
valve as shown in Figure 29.
6. Install remote receiver unit onto remote/
blower bracket using screws provided (see
Figure 29).
INSTALLATION
Continued
Figure 29 - Installing Remote Receiver
Remote
Receiver
Figure 27 - Disconnecting Wires From
Control Valve
Figure 28 - Attaching Battery to Receiver
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Control
Valve
Jumper
Wire
White
Wire to TH
Terminal
on Control
Valve
Red Wire
to TPTH
Terminal on
Control Valve
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery (not in-
cluded). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Figure 30 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit