Tri Tool 204B Beveler - Manual (Page 11)

11
Model 204B BEVELMASTER™
92-0699 : Rev. 060412
PIPE CUTTING CAPACITIES
Basic Pipe Sizes
1” Pipe
Schedule 40 (Small Mandrel required to mount in 1” schedule 80 and
above.)
1 1/4” through 2 1/2” Pipe
Up to Schedule 80
3” through 4” Pipe
Up to Schedule 40
* Some Schedules may require optional equipment.
Basic Tube Sizes
Up to .250” (6.4 mm) wall tubing with a maximum OD of 4.50” (114.3 mm)
and a minimum ID of 1.25” (31.7 mm) may be beveled with standard mandrel.
Wall Thickness Capacity (Limitations)
Wall thickness of schedules listed, .276” (7 mm) maximum, in the range listed
can be machined without limitations.
Wall thicknesses greater than .276” (7 mm) require special procedures and
are subject to Duty Cycle limitations to prevent motor damage. Contact Tri
Tool Inc. for heavier wall procedures.
Counterboring Operations
The tool will counterbore pipe and tubing with an ID of 1.50” (38.1 mm) to
4.33” (110.2 mm).
DUTY CYCLE
The 204BE with an electric motor (P/N 58-0147 or equivalent) duty cycle on high
cutting load applications (see above), is limited to 50% ‘On’ time with a maximum of
five (5) minutes continuos ‘On’ time.