Tri Tool 204B Beveler - Manual (Page 15)

15
Model 204B BEVELMASTER™
92-0699 : Rev. 060412
NOTE:
Disassembly of a power unit voids warranty, except when performed by a
TRI TOOL INC. designated repair technician. A letter of designation is
required.
AIR MOTOR LUBRICATION
No direct maintenance is normally required on the air motor.
However, the air supply must flow through a filter/regulator/lubricator (FRL)
unit or separate units before arriving at the air motor.
The FRL unit must be maintained as required, frequency dependent on the basic air
supply, to keep the water trap drained, filter cleaned and the lubricator oil reservoir
filled so that a drop of oil every two (2) to five (5) seconds is flowing.
If the Model 204B BEVELMASTER™ is to be left idle for 24 hours or more
after being run on ‘wet’ air, it is advisable to squirt oil directly into the air motor
inlet and run the motor for two (2) to three (3) seconds.
This will prevent rusting and ‘freezing‘ of the rotor vanes.
Grease Port
Verify that there is adequate grease in the gear box. Gears and bearings are to be
lubricated using a lithium based grease.