Trouble shooting – Tri Tool 204B Beveler User Manual
Page 32
32
TRI TOOL INC.
92-0699 : Rev. 060412
Problem:
The Tool Bit Chatters
The tool bit is loose or overextended.
The tool bit is damaged.
The tool holder is too loose in the slides.
The cutting speed is too fast.
The clamping pads are loose on the pipe or tube.
Cutting fluid is required.
The main bearing pre-load is loose.
Problem:
There is excessive Tool Bit wear
The pipe or tube material is too hard or abrasive.
The cutting speed is too fast.
Cutting fluid is required.
A dull Tool Bit is causing surface hardening conditions (Stainless pipe or
tubing).
There is scale or other foreign matter on the pipe or tube, which is dulling the
tool bit at the start of the cut.
The tool bit is incorrect for the material being cut.
Problem:
The surface finish is rough
The tool bit is dull, chipped, etc.
Metal buildup on the cutting edge of the tool bit is creating a false cutting
edge.
Cutting fluid is required.
Problem:
There is a loss of air power
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
TROUBLE SHOOTING