Maintenance – Tri Tool 204B Beveler User Manual
Page 14
14
TRI TOOL INC.
92-0699 : Rev. 060412
NOTE:
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter or oil as
specified for the air motor.
Air supply for the Model 204B BEVELMASTER™ with an Air Motor requires an
adequate filter/regulator/lubricator (FRL) to be used.
A maximum of 90 psi (621 kPa) line pressure is recommended.
The motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
When the Model 204B BEVELMASTER™ is operated in the vertical position, cutting
head up, it should be turned upside down and the chips and/or other debris removed
after each bevel has been completed.
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the cutting head during the machining operations are
removed.
Clean Up
Clean Up
Clean Up