Tri Tool 204B Beveler - Manual (Page 17)

17
Model 204B BEVELMASTER™
92-0699 : Rev. 060412
NOTE:
OPERATION
Read the operating instructions carefully before attempting to operate the Model
204B BEVELMASTER™
Use eye protection at all times when operating the Model 204B BEVELMASTER™
INSTALLATION
Select the recommended jaw blocks for the pipe size to be machined.
Gently slide the mandrel assembly into the Model 204B BEVELMASTER™ until it
comes to a stop against the torque acceptance key.
Rotate the mandrel assembly as required to engage the torque acceptance key of
the Model 204B BEVELMASTER™ with the slot in the mandrel shaft.
Since the mandrel shaft will contact the torque acceptance key before the
feed nut engages the mandrel shaft threads, caution should be taken not to
force, or allow, the machine to impact the lead threads of the feed nut with the
lead threads of the mandrel.
Rotate the feed handle clockwise to engage the feed nut with the thread on the
mandrel shaft.
The Model 204B BEVELMASTER™ with the mandrel assembly installed maybe
mounted into the pipe or tube as one unit.
Tool Bit
Mandrel
Assembly
Feed
Handle
Draw Nut