Tri Tool 204B Beveler - Manual (Page 19)

19
Model 204B BEVELMASTER™
92-0699 : Rev. 060412
CAUTION:
CAUTION:
WARNING:
Verify a clearance of 1/8” (3 mm) minimum between the tool bit and the pipe face.
Select the tool bit(s) required to machine the pipe to the configuration desired.
Use of dull or improperly designed tool bits or tool bits not manufactured by
TRI TOOL INC. may result in poor performance and may constitute abuse of
the machine and therefore voids the TRI TOOL INC. factory warranty.
When performing any multiple machining operation such as facing and beveling, the
facing tool bit should be installed as shown.
Insert the tool bit(s) into the slot(s) in the cutting head.
The cutting edge of the tool bit(s) must be located on the radial centerline.
Insure that no tool bit is installed backwards.
Make sure that there is a clearance between the tool bit(s) and the mandrel.
Tighten the setscrews to secure the tool bit in the tool bit slot.
Adjust the bevel tool bit radially to control the land width.
Adjust the cam to alter the width of the land with the facing tool bit.
Attach the proper air supply line to the Model 204B BEVELMASTER™
Cam Adjustment
Lock (On the Side)
Cutting Edge, Tool Bit,
Facing (Land)
Cutting Edge,
Tool Bit, Beveling
Cam Adjustment
Cutting Head
Rotation