Tri Tool 204B Beveler - Manual (Page 20)

20
TRI TOOL INC.
92-0699 : Rev. 060412
WARNING:
CAUTION:
NOTE: Check that the filter/regulator/lubricator (FRL) is installed and set properly.
MACHINING SEQUENCE
Depress the air motor trigger. Adjust the cutting speed by rotating the flow valve at
the air connection.
Rotate the feed handle clockwise to bring the tool bit(s) and pipe closer together.
DO NOT OVERRIDE THE DEADMAN SWITCH ON THIS UNIT. Locking
down, obstructing, or in any way defeating the deadman switch on this unit
may result in serious injury.
The actual machining operation will begin when the first tool bit contacts the
pipe.
When the pipe end is not square to the pipe axis, the Tool Bit will contact only a
small segment of the pipe during each revolution.
Flow Control Valve
Deadman Switch
Set Screws
Tool Bit
Cutting Edge
Rotation