Wavetronix SmartSensor Matrix (SS-225) - User Guide - Manual (Page 22)

In this chapter
˽ Click 650
˽ Click 600
˽ Preassembled Backplate
˽ Terminating SmartSensor 6-conductor Cables
2
Once you have installed the sensor, the next step is to connect it into the larger installation
at the intersection—specifically, to connect the sensor to equipment in the traffic cabinet.
There are several ways of doing this, but they all have the same purpose, which is providing
the sensor with the following:
˽ Clean, reliable DC power
˽ Surge protection
˽ Communication (so that you can connect to the Matrix with the SmartSensor Manager
Matrix software on your computer in order to configure the sensor)
˽ A connection from the sensor to the intersection controller
The following three sections will talk about the three most common ways of setting up such
an installation. Note that all of the solutions below are designed to connect up for four sen-
sors—one for each approach in a standard intersection.
Cabinet Solutions
2