Westermo ED-10 TCP - Manual (Page 18)

18 6609-2211
The ED-10 TCP network performance can be optimized for minimum delays or minimum
network loading. By default it is optimized for minimum delays, which is the recommend-
ed setting under normal conditions. But for transfer of large amount of continuous data at
high serial data rate it is recommended to use mode 4 which is optimized for maximum
throughput and minimum network loading.
Server status information is always available, locally at serial CH2 or remotely by a telnet
connection to port 23.
The packing algorithm can be configured to transmit data immediately or buffer data until
a transmit requirement is fulfilled. The transmit requirement depend on received data at
serial interface CH1 and can be:
1. An end of frame character is received.
2. An end of frame delay has elapsed since last received character.
3. A maximum number of bytes have been received.
The serial server and remote clients are identified by IP address and protocol number.
Configuration mode
Local or remote configuration is managed by either a terminal programme or by ED-Tool.
ED-Tool is a Windows based setup programme, which provides easy configuration.
Configuration is also possible by using terminal programmes (e.g. HyperTerminal for local
configuration or Telnet for remote configuration). A hardware switch ensures restore of
default settings.
Config mode will be entered; automatically by ED-Tool, manually by terminal programme
or when power is switched on with restore default setting switch set.
First time configure: ED-10 TCP is shipped with IP-address 10.0.0.10.
Please make sure that 10.0.0.10 is compliant to your network, before ED-10 TCP
is connected. Otherwise use serial interface to locally set a valid IP address.
A valid IP address must be compliant with the network in use and not chosen arbitrarily,
ask your network administrator when in doubt.