Ensemble Designs BrightEye 72 SDI to HDMI Converter, Color Corrector and Broadcast Confidence Monitor - Manual (Page 15)

www.ensembledesigns.com BrightEye 72 and 72-F - Page 15
3G/HD/SD SDI to HDMI Converter User Guide TM BrightEye 72 and 72-F
Module Configuration and Control
There are two methods for controlling and operating the BrightEye 72/72-F:
1. From the front panel (with or without on-screen display on the HDMI out);
2. With the BrightEye PC or Mac Control application.
When controlling the module from the front panel, most, but not all of the control settings and
parameter choices will be available. For more comprehensive control, use the BrightEye PC or Mac
Control application.
Front Panel Controls and Indicators
The front panel shown in the figure below provides status indicators and control over video and audio
output.
Status Indicators
The following status indicators are provided on the front panel:
• In – Illuminates green when there is a valid input signal detected.
• Adjust – Choices include Bright, Contrast, Chroma, and Hue. The LED will be green when the
parameter is set to its nominal setting. The LED will turn red when the parameter is adjusted
away from the nominal setting.
• Display – Choices include CC (closed caption), Aud VU (Audio VU), TC (timecode), and
Graticule. The LED will be green if the parameter is turned on. The LED will extinguish if the
parameter is turned off.
• Enable – Choices include Test (test signals) and H/V (horizontal and/or vertical shift). The LED
will be green if the parameter is turned on. The LED will extinguish if the parameter is turned
off.
• Audio – Choices include Gain and VU.
The Gain LED will be green when the parameter is set to its nominal setting. The LED will turn
red when the parameter is adjusted away from the nominal setting.
The VU LED indicates the output audio level of the sum of channels 1 and 2. The LED will be
green when the audio level is at or below the digital reference level. The LED lights yellow