H3C Technologies H3C WA3600 Series Access Points - Manual (Page 356)

343
Figure 375 Configure the same channel
3. Enable 802.11n (2.4GHz) radio (By default, 802.11n (2.4GHz) is enabled.).
Select Radio > Radio from the navigation tree to enter the Radio page. Make sure 802.11n
(2.4GHz) is enabled.
4. Enable WDS:
a. Select Wireless Service > WDS from the navigation tree.
b. Select the box corresponding to 802.11n (2.4GHz).
c. Click Enable.
Figure 376 WDS setup page
5. Configure the access service
NOTE:
For how to configure the access service on the repeater, see " Wireless service configuration example ."
You can strictly follow the steps in Wireless service configuration example to configure the access service
on the repeater.