H3C Technologies H3C SecPath F1000-E - Manual (Page 217)

206
Task Command Remarks
Enable information display in a detailed
manner.
verbose Enabled by default.
Enable FTP related debugging when the
firewall acts as the FTP client.
debugging Disabled by default.
Terminating an FTP connection
Task Command Remarks
Terminate the connection to the FTP server
without exiting FTP client view.
• disconnect
• close
Use either command in FTP
client view.
Terminate the connection to the FTP server
and return to user view.
• bye
• quit
Use either command in FTP
client view.
FTP client configuration example
Network requirements
• As shown in Figure 109 , use the SecPath as an FTP client and PC as the FTP server. Their IP
addresses are 10.2.1.1/16 and 10.1.1.1/16 respectively. The SecPath and PC are reachable to each
other.
• The SecPath downloads a boot file from PC for device upgrade, and uploads the configuration file
to PC for backup.
• On PC, an FTP user account has been created for the FTP client, with the username abc and the
password abc.
Figure 109 Network diagram
Configuration procedure
# Examine the storage medium of the device for insufficiency. If no sufficient free space is available, use
the delete/unreserved file-url command to delete unused files. (Details not shown.)
# Log in to the server through FTP.
<Sysname> ftp 10.1.1.1
Trying 10.1.1.1
Connected to 10.1.1.1
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password: